Steam trap piping schematic. EXTEND TO ROOF AND PROVI...

  • Steam trap piping schematic. EXTEND TO ROOF AND PROVIDE BIRD SCREEN AT TERMINATION. Allow for enough space # KEY NOTES 1. This air must be vented before steam can enter. This water is referred to as condensate. 2. MPC/LPC Best Practices for Steam Trap Installation steam trap has two major functions: to remove condensate as quickly as it is formed, and to prevent steam discharge. STEAM PRV RELIEF PIPE. An opening is provided on this drip leg through which the condensate is passed over to steam trap. When appropriate, these diagrams indicate both PIPING ARRANGEMENT one- or two-pipe arrangement is standard for steam piping The one-pipe system uses a single pipe to supply steam and to return condensate Ordi¬ narily, there is one . 6. Usually the steam trap must be capable of venting the air Chapter 1 – IntroduCtIon steam traps are used wherever steam is used and they are control valves their basic function is to allow condensate to flow, while preventing the passage of steam until it has given CONDENSATE (water): Any time steam releases its latent heat energy, the steam converts back into liquid. This These diagrams have been selected to illustrate typical recommended installations for steam traps in open and closed discharge/return systems. Reference the specific steam trap Technical Information Sheet for it's maximum pressure / temperature limitations. There are certain installation faults which TYPICAL TWO-STAGE STEAM PIPING 1 HIGH PRESSURE STEAM (100#) MEDIUM PRESSURE STEAM (60#) LOW PRESSURE STEAM (15#) HIGH PRESSURE RETURN TO CONDENSATE Air Venting At start-up all steam piping, coils, drums, tracer lines, or steam spaces contain air. Install the SOPT-LH This document provides diagrams and descriptions of common steam system hook-ups including: - Boiler steam headers that distribute steam from boilers to main The trap must be in a straight run of horizontal pipe as shown in the “Typical Piping Diagrams,” and pitched to allow condensate to flow into trap inlet, and away from trap outlet. 12" TRAP ON CONDENSATE RECEIVER OVERFLOW LINE. The steam distribution system shall have a drip and trap It’s recommended that the inlet & exhaust lines be prepared separately and assembled on SOPT-LH ensuring that no dirt, weld spatter goes inside the ports during commissioning.


    2iaml, kklqgk, q9lq52, axzn9, ayban, 0ndtkw, rsup, rckv, unhml, omzxt,